- Meant to be installed from the left to the right
- The dovetail has a progressive taper to allow for easier install
- Mounting hardware included
- 2 Button Head Cap Screws – Provided for Vortex Viper and Venom Sights
- 2 Flat Head Cap Screws – Provided for Burris FastFire and Docter Sights
- The screws require a 5/64” allen wrench for installation
Our sights for Glock are meant to be installed from the left to the right. The dovetail has a progressive taper to allow for easier install.
Simply remove the rear sight on your gun and replace it with our mount in order to mount your Vortex Viper/Venom, Burris FastFire, or Docter red-dot sight. No alterations are required.
You can take our mount off and replace your rear sight at any time. Mounting hardware included.
This mount fits Glocks all generation:
– Glock 17
– Glock 19
– Glock 20
– Glock 21
– Glock 22
– Glock 23
– Glock 24
– Glock 26
– Glock 27
– Glock 29
– Glock 30
– Glock 31
– Glock 32
– Glock 33
– Glock 34
– Glock 35
– Glock 37
– Glock 38
– Glock 39
– Glock 41
– Glock 42
– Glock 43
– Glock 46
– Canik TP9SF
– Bersa BP9CC
Does not fit Glock MOS models:
– Glock 17 Gen 4 MOS
– Glock 19 Gen 4 MOS
– Glock 34 Gen 4 MOS
– Glock 40 Gen 4 MOS
– Glock 41 Gen 4 MOS
– Glock 35 Gen 4 MOS
– Glock 34 Gen 5 MOS
Installation Instructions
– Remove the rear sight
– Install the EGW Sight Mount in the dovetail
– Tighten set screw (if applicable)
– Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
– Apply blue Loctite to the provided mounting screws
– Torque mounting screws to 15in/lbs
DISCLAIMER: This product is not manufactured, authorized, endorsed, or warranted by GLOCK. GLOCK does not warrant or represent that this product is compatible with GLOCK pistols.
